Skip to main content
Service area · 3 ZIP codes · 4 neighborhoods

Converse, TX

Full chimney services across all of Converse — 28k residents, every neighborhood covered. CSIA-certified, same-week scheduling.

28k
Residents in metro
3
ZIP codes covered
4
Neighborhoods
2 min
Human reply · 7 AM – 12 AM
Neighborhoods

Every neighborhood in Converse.

We service every neighborhood and ZIP in Converse. Find yours below or just give us a call — we'll confirm coverage and schedule on the spot.

Kensington Ranch
Stonebridge
Willow Run
Foster Meadows

Don't see yours? Call (469) 838-6843 — if it's in Converse, we cover it.

Climate & code file · Greater San Antonio

San Antonio is not one chimney market — it is a dozen of them stacked inside one city, and Chimney Standard services them with a single, unvarying standard. A century-old masonry stack on a King William Victorian, a 1970s ranch firebox off Loop 410, and a builder-grade prefab in a 2015 Stone Oak subdivision are three completely different systems, and what makes the metro specific is the combination of light annual burn and long idle seasons — most homes light a handful of fires across a short, mild winter, then sit unused for nine months.

01

The rare hard freeze on porous stone

A Feb-2021-class freeze is the limestone killer: water already sitting inside porous stone expands and pops the face. The best defense is keeping water out of the masonry before the cold arrives — seal the breathable stone with a vapor-permeable siloxane repellent, never a film-forming coating that traps moisture inside and accelerates spalling at the next freeze.

02

Limestone & lime mortar — the one that matters most

If your Converse chimney is older Hill-Country masonry, do not let a generalist repoint it with hard gray Portland. Soft limestone was laid in a breathable, high-lime mix that flexes with the stone; modern Portland is harder than the stone around it, so it transfers stress into the limestone and drives the cracking into the face — turning a repointing job into a stone-replacement job. We read the existing mortar, match its composition and color, and repoint so the repair moves with the wall through the heat-and-freeze cycle. That's the question budget crews don't even know to ask.

03

Cedar (Ashe juniper)

Cedar needles and the heavy December–February pollen pack into spark screens and crown washes — a clogged cap is a draft problem and a fire-screen failure at once. We clear and inspect the cap on every sweep. On wood-burners we also flag cedar's hot, fast, resin-heavy burn: it glazes a flue far quicker than seasoned oak, so a cedar-burning Converse home needs a tighter sweep interval, not the generic annual default.

04

Long dormancy

A Converse flue may sit unused for ten months, then get lit hard for six weeks — long enough for animals to nest, debris to collect, and a hairline crown crack to go unnoticed. A fall sweep-and-scan before the short burning season means your first cold-front fire is on a verified, clean, code-ready flue.

Code note · Greater San Antonio

South-Texas / Hill-Country code reality: porous historic stone is sealed only with a vapor-permeable siloxane repellent (never a film-forming coating), and a Feb-2021-class freeze event is the regional benchmark for the cracked-tile and open-joint damage a Level 2 scan exists to catch.

All services

Services in Converse.

Level 1 Chimney Inspection

The annual baseline check NFPA 211 calls for.

From $129

Level 2 Chimney Inspection

Camera-scanned. Required at sale, after fires or changes.

From $279

Level 3 Chimney Inspection

The invasive tier — opened only on documented evidence.

From $900

Real Estate Transaction Report

Level 2 documentation built around closing deadlines.

From $329

Insurance Claim Documentation

Adjuster-ready evidence packets for storm and fire claims.

From $179

Code Compliance Review

Clearances, terminations, and liner sizing checked to code.

From $179

Chimney Sweep & Creosote Removal

Swept when measurement says so — not the calendar.

From $149

Masonry Repair & Tuckpointing

Failed joints and spalled brick, repaired to a written spec.

From $495

Crown & Flashing Repair

The two leak paths behind most mystery water stains.

From $249

Chimney Cap Installation

Sized, meshed, and fastened to spec — then photographed.

From $299

Chimney Liner Installation

UL 1777 stainless relining, sized to the appliance.

From $1,495

Post-Fire Chimney Inspection

The Level 2 NFPA 211 requires after a chimney fire.

From $279

CO & Combustion Safety Testing

Instrumented testing of what the appliance actually vents.

From $350

Written Certificate of Compliance

Issued when the system passes — included with the inspection.

From Included

Appliance / Fuel Change Review

The Level 2 the code requires on a fuel or appliance change.

From $279

Vent-Free Log Jurisdiction Check

Whether vent-free is legal where you live — in writing.

From $129

Animal Removal & Exclusion

Removal, plus the guard that stops the next one.

From $249

Damper Repair

Freeing and re-seating a damper that still has life in it.

From $149

Chimney Cap Repair

Re-screening and re-securing a cap worth saving.

From $179

Chase Cover Repair

Sealed and re-flashed before the framing beneath goes.

From $249

Chimney Crown Rebuild

A poured reinforced crown with overhang and drip edge.

From $1,195

Chimney Rebuild Above Roofline

Rebuilt from the roofline up, on a base proven sound.

From $1,495

Full Chimney Rebuild

Quoted after a structural assessment, never from a photo.

From $3,500

Smoke Chamber Parging

Corbelled brick smoothed to code with refractory mortar.

From $695

Breathable Water Repellent

Vapor-permeable repellent — never a film-forming sealer.

From $425

Throat Damper Replacement

A warped or cracked throat damper, replaced and tested.

From $349

Top-Sealing Damper Installation

A gasketed damper at the crown that actually seals.

From $449

Multi-Flue Chimney Cap

One fabricated cap covering every flue — and the crown.

From $599

Rigid Stainless Liner

Heavier-wall rigid stainless for straight flue runs.

From $1,895

Cast-In-Place Liner

A poured masonry liner that reinforces the flue itself.

From $3,500

Fireplace Insert Installation

Labor to set and connect — unit and liner itemized.

From $895

Gas Fireplace Diagnostic

Find the fault first — fee waived when you approve the repair.

From $99

Gas Fireplace Annual Service

Burner, pilot, glass, gasket, and combustion check.

From $149

Commercial Venting Compliance

Scheduled inspections and records for commercial venting.

From $450

Emergency Chimney Assessment

Post-fire and storm triage with a written verdict.

From $250
Call us
(469) 838-6843
Hours
Mon–Sun 7:00 AM – 12:00 AM
Open Sunday 7:00 AM – 12:00 AM
HQ
Dallas, TX

Last reviewed:

15+
Years in the field
NFPA 211
Checklist
48h
Written report
< 2hr
Response
Ready when you are

Get it inspected. Get it in writing.

Flat fee confirmed when you book. Same-week scheduling. A pass/fail verdict within 48 hours.

Licensed & Insured Same-Week Scheduling Photo-Documented Findings
Emergency

24/7 Response

Chimney fire, storm hit, active leak, or a flue you're not sure about? We answer 7 AM to midnight and the assessment ends in a written safe-to-use verdict — including a do-not-use notice when the evidence supports one. After-hours dispatch runs subject to crew availability.

Emergency line